RAM 3500 Van V8-5.2L CNG VIN T (1996)
Fuel Shut-off Solenoid: Testing and Inspection
Low Pressure Fuel Shut-Off Solenoid (CNG)
Fuel Injectors And Rail
1. Unplug 2-way electrical connector located near manual gas shut-off valve.
2. Using a set of jumper wires (approximately 18 gauge wire), momentarily apply 12 volts across terminals. The 12 volt + side of jumper wire set
may be attached to either of 2 terminals on connector (polarity not important). Solenoid should click after 12 volts has been applied. If solenoid
will not click, replace fuel pressure regulator assembly.
