RAM 3500 Van V8-5.2L CNG VIN T (1996)
Fuel Tubes On Left Cylinder
5. Disconnect fuel tube at cylinder. Clean area around fitting before removal.
6. Disconnect electrical connector from fuel gauge pressure sensor.
7. Two cylinder carrier mounting bolts are located inside vehicle behind drivers seat.
8. Remove seat behind drivers seat (if equipped).
9. Partially remove floor carpeting (mat) over mounting bolts, if equipped.
Left Side Cylinder Carrier Bolts
10. Remove 2 cylinder carrier mounting bolts.
11. Raise vehicle.
12. Place and secure a hydraulic jack below cylinder/cylinder carrier assembly
Left Side Fuel Cylinder
13. Remove 2 cylinder carrier bolts at frame rail.
14. Carefully lower cylinder/cylinder carrier assembly.
