RAM 3500 Van V8-5.2L CNG VIN T (1996)
Fuel Tank Location (Gas)
5. Disconnect fuel pump electrical connector. Disconnect EVAP purge hose from pressure relief/rollover valve. Disconnect fuel hose from
filter/regulator.
6. Slide a suitable jack under tank, and apply slight pressure. Remove nuts from tank straps at the crossmembers.
7. Lower tank for removal.
INSTALLATION
1. Place fuel tank on suitable jack and raise tank into position.
2. Connect mounting straps and strap nuts.
3. Torque mounting strap nuts to 41 Nm (30 ft-lbs).
4. Connect fuel pump electrical connector. Connect EVAP purge hose from pressure relief/rollover valve. Connect fuel hose from filter/regulator.
5. Install fuel filler and vent hoses.
6. Refill tank, replace gas cap, and connect battery.
7. Using the DRB II select the Automatic Shut Down (ASD) Fuel System Test to pressurize fuel system and check for leaks.
CAUTION: Unless the test is stopped or the ignition switch is turned to the OFF position the fuel pump relay and the ASD relay will remain
energized for 7 minutes by the ASD Fuel System Test.
