RAM 3500 Van V8-5.2L CNG VIN T (1996)
Retractor Cover
5. Remove push-in fastener from seat belt retractor cover.
6. Separate cover from B-pillar.
7. Remove the seat belt retractor anchor bolt from the B-pillar.
8. Separate the seat belt retractor assembly from the vehicle.
9. Disconnect the wire harness connector for the seat belt retractor.
10. Remove the shoulder belt and retractor from the vehicle.
INSTALLATION-SHOULDER BELT RETRACTOR
1. Position the upper end of the turning loop at the roof panel.
2. Install the upper anchor bolt in the roof panel. Tighten the upper anchor bolt to 40 Nm (350 in. lbs.) torque.
3. Position the cover over the upper anchor bolt.
4. Position the retractor at the B-pillar.
5. Engage electrical wire connector.
6. Insert the retractor locating tab in the B-pillar and install the anchor bolt. Tighten the anchor bolt to 40 Nm (350 in. lbs.) torque.
CAUTION: Ensure the retractor wire harness does not interfere with the operation of the retractor or shoulder belt travel.
