RAM 3500 Van V8-5.9L VIN Z LDC (1998)
3.
Using a trim panel removal tool, remove the push-in fasteners that attach the seat riser trim shield to the rear of the driver's seat riser (Figure 1).
Set the trim shield aside.
4.
Remove the power seat wiring harness connector from the front riser crossmember and then disconnect the connector (Figure 2).
5.
Remove the nuts that attach the seat riser to the floor pan (Figure 2).
6.
Remove the driver's seat from the vehicle.
7.
Remove the nuts that attach the seat riser to the power seat track adjuster (Figure 2). Discard the seat riser.
8.
Install the new seat riser on the power seat track adjuster (Figure 2). Tighten the nuts to 16 ft-lbs (22 N.m).
9.
Install the seat assembly back into the vehicle.
10.
Install the nuts that attach the seat riser to the floorpan (Figure 2). Tighten the nuts to 55 ft-lbs (75 N.m).
11.
Connect the power seat wiring harness connector and attach it to the front riser crossmember.
12.
Install the seat riser trim shield (Figure 1).
13.
Install the seat belt buckle assembly on to the seat riser. Tighten the bolt to 29 ft-lbs (40 N.m).
14.
Reconnect the negative battery cable.
Dealer Service Instructions
IMPORTANT
DEALER SERVICE INSTRUCTIONS
Safety Recall # 781 -- Power Seat Riser
^
This service requirement applies only to 1998 model year Dodge Ram (AB) vans and wagons equipped with a power driver's seat (Sales Code --
CDG or JPS) built through March 2, 1998 (MDH 030213).
