RAM 3500 Van V8-5.9L VIN Z LDC (1998)
>
If the spray turns a purple color, continue with Step 15 of this procedure.
15.
Disconnect the large ABS control module wiring harness connector from the ABS control module by first sliding the red lock tab forward. Then
push down on the black release tab while pulling the connector from the module (Figure 7).
16.
Inspect the large ABS control module wiring harness connector:
a.
If a heat damaged (melted) connector is found, replace the wiring harness connector. Continue with Section C - ABS Control Module
Wiring Harness Connector Replacement.
If no heat damage is found continue with inspection Step b.
b.
Inspect the wire side and the terminal side of the large ABS control module wiring harness connector for green colored corrosion. If green
colored corrosion is found in one or more of the connector cavities continue with Section C - ABS Control Module Wiring Harness
Connector Replacement. If no green colored corrosion is found, continue with inspection Step c.
c.
Looking into the terminal side of the large ABS control module wiring harness connector, inspect the metal terminals for a dull finish or
discoloration. If a dull finish or discoloration is found, continue with Section C - ABS Control Module Wiring Harness Connector
Replacement because the original connector housing wire weather seals have been damaged. If no dull or discolored terminals are found
continue with Section E - Battery Tray Installation.
C. ABS Control Module Wiring Harness Connector Replacement
NOTE:
Only ABS control module wiring harness connectors with heat damage (melted), green wire terminals or dull/discolored terminals, as determined by
the inspection in Section B, require replacement.
