RAM 3500 Van V8-5.9L VIN Z LDC (1998)
7.
Install the four ABS control module mounting screws. Tighten the screws to 39 in. lbs (4.4 N.m).
8.
Continue with Section E - Battery Tray Installation.
E. Battery Tray Installation
1.
If disconnected, spray the ABS control module connector and the ABS control module wiring harness connector with Electrolyte Detection and
Neutralizing spray to ensure that all traces of acid have been neutralized.
NOTE:
When the spray remains an orange color, any remaining battery acid has been neutralized.
2.
Using compressed air, carefully blow out the connector until completely dry.
3.
If previously disconnected, connect the large and/or small wiring harness connectors to the ABS control module.
4.
Transfer the battery temperature sensor from the old battery tray to the new battery tray (Figure 14). Then discard the old battery tray.
5.
Place a small bead of RTV silicone rubber adhesive (P/N 04883971) onto the base of the new drain tube grommet.
6.
Snap the new drain tube into position on the new battery tray (Figure 14).
7.
While installing the new battery tray into position, route the drain tube through the original hole in the fender panel (Figure 15) and connect the
battery temperature sensor electrical connector.
8.
Install the battery tray mounting bolts. Tighten the bolts to 95 in. lbs. (10.7 N.m).
