RAM 3500 Van V8-5.9L VIN Z LDC (1998)
Starter Relay
13 If equipped with type-1 relay, attach test leads from LCS adapter into PDC relay cavities number 30 and 87. For location of these cavities, refer to
numbers stamped to bottom of relay.
Type-2 Relay
14. If equipped with type-2 relay, attach test leads from LCS adapter into PDC relay cavities number 30 and 87. For location of these cavities, refer to
numbers stamped to bottom of relay.
Type-3 Relay
15. If equipped with type-3 relay, attach test leads from LCS adapter into PDC relay cavities number 3 and 5. For location of these cavities, refer to
numbers stamped to bottom of relay.
16. When LCS adapter test leads are attached into relay cavities, fuel pump will be activated. Determine fuel pump amperage on DRB screen.
Amperage should be below 10.0 amps. If amperage is below 10.0 amps, and specifications for the Fuel Pump Pressure, Fuel Pump Capacity and
Fuel Pressure Leak Down tests were met, the fuel pump module is OK.
17. If amperage is more than 10.0 amps, replace fuel pump module assembly The electric fuel pump is not serviced separately.
