RAM 3500 Van V8-5.9L VIN Z LDC (1998)
3.
Remove the power seat wiring harness connector from the front riser crossmember and then disconnect the connector (if equipped) (Figure 2).
4.
Remove the nuts that attach the driver's seat riser to the floor pan (Figure 2).
5.
Remove the driver's seat assembly from the vehicle.
6.
Disconnect the airbag electronic control module (AECM) wiring connector.
7.
Remove the three (3) screws that attach the AECM to the floor pan mounting bracket (Figure 3). Discard the screws.
8.
Remove the AECM. Destroy the old AECM connector pins and then discard the old AECM.
9.
Install the supplied AECM. Position the AECM on the floor pan mounting bracket with the arrow on the housing pointing forward (Figure 3).
10.
Install the three provided AECM mounting screws. Tighten the screws to 105 in-lbs (11.8 N.m).
11.
Connect the AECM wiring connector. Make sure that the connector latches are fully engaged.
