RAM 3500 Van V8-5.9L VIN Z LDC (1998)
Seals and Gaskets: Service and Repair
32RH 3-Speed
REMOVAL
1. Raise vehicle.
2. Mark propeller shaft and axle yoke for alignment reference.
3. Disconnect and remove propeller shaft.
Removing Extension Housing Yoke Seal
4. Remove old seal with Seal Remover C-3985-B from extension housing.
INSTALLATION
1. Place seal in position on extension housing.
Installing Extension Housing Yoke Seal
2. Drive seal into extension housing with Seal Installer C-3995-A or C-3972.
3. Carefully guide propeller shaft slip yoke into housing and onto output shaft splines. Align marks made at removal and connect propeller shaft to
rear axle pinion yoke.
