RAM 3500 Van V8-5.9L VIN Z LDC (1998)
Solenoid Harness Routing
22. Verify that solenoid wire harness is properly routed. Solenoid harness must be clear of manual lever and park rod and not be pinched between
accumulator housing and cover.
GOVERNOR BODY, SENSOR AND SOLENOID
1. Turn valve body assembly over so accumulator side of transfer plate is facing down.
Governor Pressure Sensor
2. Install new O-rings on governor pressure solenoid and sensor.
3. Lubricate solenoid and sensor O-rings with clean transmission fluid.
4. Install governor pressure sensor in governor body. Then secure sensor with M-shaped retaining clip.
Governor Pressure Solenoid
5. Install governor pressure solenoid in governor body. Push solenoid in until it snaps into place in body.
