RAM 3500 Van V8-5.9L VIN Z LDC (1998)
Wiper Control Module: Service and Repair
Intermittent Wipe Module Replacement
REMOVAL
An intermittent wipe module is used on vehicles that are not equipped with the optional Vehicle Theft Security System (VTSS). See Intermittent Wipe
Module and Central Timer Module in the Description and Operation for more information.
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAGS BEFORE ATTEMPTING ANY STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER
PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Roll down the glove box from the instrument panel. Refer to Instrument Panel, Gauges and Warning Indicators/Instrument Panel/Glove Box - Roll
Down Replacement.
Instermittent Wiper Module Remove/Install
3. Reach through and above the glove box opening to access the intermittent wipe module. Push the module towards the front of the vehicle to
disengage the snap-fit slot on the intermittent wipe module from the slide tab of the mounting bracket on the instrument panel armature.
4. Lower the intermittent wipe module into the instrument panel glove box opening far enough to access and unplug the wire harness connector.
5. Reverse the removal procedures to install.
