RAM 4500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
Exhaust Pipe: Service and Repair
Exhaust Pipe - Installation
6.7L DIESEL
1. Using a new flange gasket, position exhaust pipe (3) on DOC/DPF flange and turbocharger flange.
2. Install flange nuts (2). Tighten nuts (2) to 54 Nm (40 ft. lbs.)
3. Install a new exhaust pipe-to-turbocharger clamp (5). Do not tighten clamp at this time.
4. Install transmission mounted exhaust pipe support (4). Tighten bolts to 43 Nm (32 ft. lbs.).
5. 4X4 Vehicles - Install transmission crossmember See: Body and Frame/Frame/Cross-Member/Service and Repair/Crossmember - Installation .
6. 4X4 Vehicles - Install transfer case skid plate See: Body and Frame/Frame/Skid Plate/Service and Repair/Transfer Case Skid Plate/Installation .
7. Check the exhaust system for contact with the body panels. A minimum of 25 mm (1.0 in.) is required between the exhaust system components and
body/frame parts. Make the necessary adjustments, if needed.
8. Tighten turbocharger clamp nut to 16 Nm (150 in. lbs.).
9. Lower the vehicle.
10. Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.
