RAM 4500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
NOTE: After setting toe to specifications, normalization of the tie rod to knuckle must be verified to be sure that the adjustments are correct.
7. For 2500/5500, to normalize, verify the lower surface of the outer tie rod socket (2) is parallel to the upper surface ofthe knuckle (1). Rotate the
drag link/tie rod until ball joint to knuckle is parallel.
NOTE: Toe setting may change during tightening, Make sure to verify reading after tightening.
8. Verify the steering wheel is straight and the toe settings are correct (repeat steps 2-6 if necessary).
9. Road test the vehicle.
Misalignment Check - Tie Rod Ball Stud Housing
TIE ROD BALL STUD HOUSING MISALIGNMENT CHECK 4500/5500
Special Tools
NOTE: This procedure describes how to check for parallel alignment of the RH and LH steering tie rod ball stud housings. It is essential to
have these within +/-3 degrees of parallel to prevent ball stud durability issues.
NOTE: All views, left side shown, right side similar.
