RAM 4500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
1. Install rear clutch steel check ball (1) and rear servo plastic check ball (2) into the transfer plate (3).
2. Install filter screen (2) in upper housing separator plate (1).
3. Align and position upper housing separator plate (3) on transfer plate (2).
4. Install brace plate (1). Tighten brace attaching screws to 4 Nm (35 in. lbs.) torque.
5. Install remaining separator plate attaching screws. Tighten screws to 4 Nm (35 in. lbs.) torque.
UPPER AND LOWER HOUSING
1. Position upper housing so internal passages and check ball seats are facing upward. Then install check balls in housing (1, 2). Seven check balls
are used. The single large check ball (2) is approximately 8.7 mm (11/32 in.) diameter. The remaining 6 check balls are approximately 6.3 mm
(1/4 in.) in diameter.
