RAM 4500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
3. Disconnect the reservoir washer hose from the barbed nipple of the inline fitting at the engine compartment washer hose in the right headlamp and
dash wire harness and allow the washer fluid to drain from the reservoir into a clean container for reuse.
4. Disconnect the left headlamp and dash wire harness (1) connector from the washer fluid level switch connector receptacle (5).
5. Disconnect the left headlamp and dash wire harness connector from the washer pump/motor unit connector receptacle (3).
6. Remove the two screws (3) that secure the washer reservoir (4) to the left vertical member of the radiator support (2).
7. Lift the washer reservoir far enough to disengage the locator post on the bottom of the washer reservoir from the locator hole in the bracket at the
base of the left vertical member of the radiator support.
8. Remove the washer reservoir from the left side of the engine compartment.
6.7L Diesel Engine
6.7L DIESEL ENGINE
1. Disconnect and isolate the battery negative cable.
2. Disconnect the coolant overflow hose from the nipple on the radiator filler neck. It is not necessary to open or drain the engine cooling system.
See: Engine, Cooling and Exhaust/Cooling System/Coolant Reservoir/Service and Repair/Coolant Recovery Container - Removal .
3. Disengage the reservoir washer hose from the integral routing clips on the top of the radiator fan shroud.
4. Disconnect the reservoir washer hose from the barbed nipple of the inline fitting at the engine compartment washer hose in the right headlamp and
dash wire harness and allow the washer fluid to drain from the reservoir (2) into a clean container for reuse.
5. Disconnect the left headlamp and dash wire harness connector (5) from the washer fluid level switch connector receptacle (4).
6. Disconnect the left headlamp and dash wire harness connector (1) from the washer pump/motor unit connector receptacle (3).
