RAM 50 2WD L4-156 2556cc 2.6L VIN 7 2-bbl (1983)
Neutral Safety Switch: Service and Repair
1.
Loosen shift lever handle setscrew, then remove shift lever handle.
2.
Remove shift position indicator attaching screws, then the position indicator by lifting upward.
3.
Disconnect shift position indicator light from indicator assembly, then the neutral safety switch wiring.
4.
Loosen neutral safety switch adjustment screws, then remove attaching screws and switch.
5.
Reverse procedures to install, noting the following:
Fig. 8 Positioning selector lever for neutral safety switch installation. Ram Raider & 1984-86 Ram 50
a. Position selector lever as shown, install switch on selector lever bracket leaving screws loose, then connect suitable ohmmeter to switch
terminals.
Fig. 9 Neutral safety switch clearance. Ram Raider & 1984-86 Ram 50
b. Move switch forward and backward through range of adjustment noting meter indication, and scribe alignment mark between switch and
bracket in position where continuity is first indicated.
c. Set clearance, between switch and selector to 0.06 inch for 2 wheel drive models or 0.1 inch for 4 wheel drive models, ensure scribed marks
are aligned, then tighten switch mounting screws.