RAM 5500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
Courtesy Lamp Bulb: Service and Repair
Removal
BULB
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Remove the center bezel lamp unit (4) from the instrument panel center support structure. See: Service and Repair/Center Bezel Lamp - Removal
.
3. Depress the latch tab (2) and slide the hood (1) off of the end of the lamp housing.
4. Pull the base of the bulb (3) straight out of the bulb holder within the lamp housing.
