RAM 5500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
1. Position the rear seat belt turning loop height adjuster (1) to the inside of the upper C-pillar.
2. Engage the tab on the height adjuster into the slot in the sheet metal of the inner C-pillar.
3. Hand tighten the lower of the two screws that secure the height adjuster to the C-pillar far enough to keep the tab on the adjuster engaged in the
C-pillar slot.
4. Install the upper screw that secures the seat belt turning loop height adjuster to the upper C-pillar, then tighten both the upper and lower screws to
39 Nm (29 ft. lbs.).
5. Reinstall the upper trim (2) onto the inside of the C-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/C-Pillar Trim Panel-Installation .
6. Position the seat belt turning loop (3) onto the height adjuster on the upper C-pillar.
7. Install and tighten the screw (5) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. lbs.).
8. Engage the upper edge of a new trim cover (4) over the top of the turning loop. Then squeeze the lower end of the trim cover and the turning loop
together firmly and evenly until the engagement tabs of the trim cover snap into the slots of the turning loop.
