RAM 5500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
23. Install Special Tool 10326-1 and 10326-2 onto the bottom surface of the left side tie rod end as shown in Figure 7.
24. Adjust the left tie rod end so that the same angle appears on the inclinometer gauge as was measured on the right tie rod end.
NOTE:
The objective is to have both tie rod ends at the same angle.
25. Tighten tie rod adjuster clamps to 40 ft. lbs. (54 N.m).
26. Recheck both right and left tie rod end angles. The right and left tie rod end angles must be the same. If the tie rod end angles are different, loosen
the left tie rod adjuster clamp and readjust left tie rod as required.
WARNING:
Failure to have the same right and left tie rod end angles will cause the condition this recall is addressing to still be present.