RAM 5500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2008)
Wiper Motor: Service and Repair
Wiper Module - Removal
REMOVAL
1. Remove both wiper arms (4) from the wiper pivots. See: Wiper Arm/Service and Repair/Wiper Arms - Removal .
2. Unlatch and open the hood.
3. Disconnect and isolate the battery negative cable.
4. Remove the cowl plenum cover/grille panel (5) from over the cowl plenum (8). See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and
Repair/Removal .
5. Disconnect the left headlamp and dash wire harness connector (7) from the wiper motor pigtail wire connector.
6. Remove the two screws (9) that secure the wiper module (6) to the top of the cowl plenum panel at the pivot brackets.
7. Remove the screw that secures the wiper module to the bottom of the cowl plenum panel.
8. Remove the wiper module from the cowl plenum panel as a unit.