Door Latch Campaign - Rear Door Latch TSB
2. Remove the inside door handle bezel (Figure 2).
3. Remove the mirror flag bezel.
4. Remove the power widow switch from the door panel (Figure 2).
5. Remove the six door panel retaining push pins.
6. Unsnap the door panel from the door shell.
7. Remove the door speaker.
8. Disconnect the power mirror electrical connectors.
9. Open the door latch access panel.
10. Place the window in the halfway up position.
11. Unsnap the window glass from the window regulator lift plate (Figure 3).
12. After unsnapping the glass from the window regulator, slide the window glass up to the top of its travel and tape the glass into position.
13. Disconnect the negative battery cable.
