RAM SRT-10 Pickup V10-505 8.3L (2004)
6. Remove the disc brake caliper.
INSTALLATION - FRONT
NOTE: Install a new copper washers on the banjo bolt when installing
1. Install the disc brake caliper.
CAUTION: Verify brake hose is not twisted or kinked before tightening fitting bolt.
2. Install the banjo bolt with new copper washers to the caliper. Tighten to 27 Nm (20 ft. lbs.)
3. Install the caliper slide pin bolts tighten to 32 Nm (24 ft. lbs.)
4. Bleed the base brake system.
5. Install the tire and wheel assembly.
6. Lower the vehicle.
Rear
REMOVAL - REAR
1. Raise and support vehicle.
2. Remove the wheel and tire assembly.
3. Compress the disc brake caliper using tool #C4212F.