RAM SRT-10 Pickup V10-505 8.3L (2004)
Cruise Control Vacuum Reservoir: Service and Repair
REMOVAL
The vacuum reservoir (1) is located in the engine compartment under the fresh air cowl grill panel.
1. Remove wiper blades and arms.
2. Remove fresh air cowl grill.
3. Disconnect vacuum line (2) at reservoir.
4. Remove 2 reservoir mounting nuts (3).
5. Remove reservoir from cowl.
INSTALLATION
1. Position reservoir onto 2 weld studs.
2. Install 2 mounting nuts and tighten. Refer to torque specifications.
3. Connect vacuum line to reservoir fitting.
4. Install cowl grill.
5. Install wiper arms/blades.
