RAM SRT-10 Pickup V10-505 8.3L (2004)
11. Using lifting fixture TOOL 9363 and support TOOL, raise the front of the engine
12. Remove transmission to oil pan fasteners.
13. Remove oil pan bolts and remove oil pan.
NOTE: Clean and inspect oil pan gasket. The pan gasket can be used again if in good condition.
INSTALLATION
1. Clean gasket surfaces. Inspect oil pan gasket. Replace as necessary
2. Apply an 1/8 in. bead of Mopar Engine RTV at the two joints between the cylinder block to timing chain case cover and the two joints between the
rear main seal retainer and engine block.
3. Position oil pan and gasket to engine block, seat the oil level indicator tube in the oil pan and hand start all fasteners.
