RAM SRT-10 Pickup V10-505 8.3L (2004)
Compressor Clutch: Service and Repair
Sanden A/C Compressor
REMOVAL
NOTE: The A/C compressor clutch can be serviced in the vehicle. The refrigerant system can remain fully-charged during compressor clutch, pulley
and bearing assembly, or coil replacement.
1. Disconnect and isolate the negative battery cable.
2. Remove the accessory drive belt.
3. Disconnect the engine wire harness connector for the A/C compressor clutch coil from the clutch field coil wire harness connector on the top of the
A/C compressor.
4. Remove the bolts that secure the A/C compressor to the mounting bracket and support the A/C compressor.
5. Insert the two pins of the spanner wrench (Special Tool C-4489 or equivalent) (2) into the holes of the clutch plate (1). Hold the clutch plate
stationary and remove the nut.
6. Remove the clutch plate and shims.
7. Using snap ring pliers (Special Tool C-4574 or equivalent) (2), remove the snap ring that secures the pulley and bearing assembly (1).
