RAM SRT-10 Pickup V10-505 8.3L (2004)
PRESSURE HOSE - PUMP TO FAN
REMOVAL
NOTE: Review all Warnings and Cautions.
CAUTION: Cap all open ends of power steering hoses, power steering pump fittings and steering gear ports when disconnected. This will prevent the
entry of foreign material into the components during servicing.
1. Siphon power steering fluid from fluid reservoir.
2. Unthread power steering pressure hose quick-connect (10) from power steering pump pressure fitting. Drain excess power steering fluid from line.
3. Unthread power steering pressure hose quick-connect (8) from hydraulic fan (6). Drain excess power steering fluid from line.
4. Remove power steering pressure hose (7) from routing clip on cooling module (5) . Remove hose.
INSTALLATION
NOTE: Before installing power steering hose, replace used o-rings as necessary. Clean hose ends and open ports with a lint-free cloth. Lubricate
o-rings with clean power steering fluid.
1. If pressure hose is separate from quick-connect fittings:
a. Thread quick-connect fitting (8) into cooling fan port. Tighten fitting to 28 Nm (21 ft. lbs.) torque.
b. Slide fan end of pressure hose tube into quick-connect fitting until it locks into place.
