RAM SRT-10 Pickup V10-505 8.3L (2004)
1. Install return hose into engine compartment using reverse of how it was removed.
2. Install hose at fluid cooler to the quick connect (1).
3. Install front air deflector.
4. Lower vehicle.
5. Thread return hose tube nut on gear end of hose into power steering gear port. Tighten tube nut to 28 Nm (21 ft. lbs.) torque.
6. Fill power steering pump reservoir to correct fluid level.
7. Perform Power Steering Pump Initial Operation procedure.
8. Check for leaks at all hose connections.
Return Hose - Cooler to Pump
RETURN HOSE - COOLER TO PUMP
REMOVAL
NOTE: Review all Warnings and Cautions.
CAUTION: Cap all open ends of power steering hoses, power steering pump fittings and steering gear ports when disconnected. This will prevent the
entry of foreign material into the components during servicing.
1. Siphon power steering fluid from fluid reservoir.
2. Remove clamp, then return hose at reservoir.
3. Raise vehicle.
4. Remove front air deflector.
5. Disconnect the quick connect filling (6) at the return hose from the metal line at the cooler using special tool 8875.
INSTALLATION
NOTE: Before installing power steering hose, replace used o-rings as necessary. Clean hose ends, fittings and open ports with a lint-free cloth.
Lubricate o-rings with clean power steering fluid.
1. Install hose into engine compartment using reverse of how it was removed.
