RAM SRT-10 Pickup V10-505 8.3L (2004)
Crankshaft Position Sensor: Service and Repair
REMOVAL
The sensor is located at the rear lower passenger side of motor.
1. Disconnect electrical connector from crankshaft position sensor.
2. Remove sensor mounting bolt.
3. Pull sensor out. A light tap to top of sensor may ease removal.
INSTALLATION
1. Slide the sensor into the hole.
2. Install and tighten the mounting bolt to 11 Nm (95 in. lbs.) torque.
3. Connect the electrical connector to the sensor and lock.
