RAM SRT-10 Pickup V10-505 8.3L (2004)
16.
Turn the ignition to the "Run" position (engine not running).
17.
Download the flash from the DRBIII(R) to the vehicle. Using the DRBIII(R) select:
a.
"Vehicle Flash"
b.
Follow the directions on the DRBIII(R) screen. When the flash process is complete, proceed to Step # 18.
18.
If the vehicle is a 2003 and later AN or 2002 or later DN or DR model, proceed to Step # 19. If not proceed to Step # 23.
19.
Turn the ignition to the "Off" position.
20.
Connect the CAB electrical connectors.
21.
Turn the ignition switch to the "Run" position (engine not running).
22.
Using the DRBIII(R), check the pinion factor in the CAB to be sure that it was not erased during the flash process. If the pinion factor is not
present or is not correct, enter the correct pinion factor. Proceed to Step # 23.
NOTE:
Due to the PCM programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKIM, etc.) within the vehicle, if so equipped.
Some DTC's may cause the MIL to illuminate. Check all modules using "Module Scan", record the DTC's, and erase these DTC's prior to returning
the vehicle to the customer. Erase any DTC's in the PCM only after all other modules have had their DTC's erased.
NOTE:
The following step is required by law.
23.
Type the necessary information on the "Authorized Modification Label" p/n 04275086AB and attach near the VECI label (Fig. 1).
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
