RAM SRT-10 Pickup V10-505 8.3L (2004)
1. Align fluid cooler line (3) with quick connect fitting (1) while pushing straight into the fitting.
2. Push in on oil cooler line until a "click" is heard or felt.
3. Slide dust cap (4) down the oil cooler line and snap it over the quick connect fitting until it is fully seated and rotates freely. Dust cap (4) will only
snap over quick connect fitting when the cooler line is properly installed.
NOTE: If dust cap will not snap into place, repeat assembly step #2.
Fluid Cooler Tube
FLUID COOLER TUBE
REMOVAL
1. Drain and siphon the power steering fluid.
2. Remove the underneath splash shield.
3. Disconnect the quick connect power steering fluid cooler tubes (3) from the fluid cooler (1) using special tool 8875 (2).
