RAM SRT-10 Pickup V10-505 8.3L (2004)
2. Unthread power steering return hose tube nut from power steering gear port (1). Pull tube out of gear port and drain excess power steering fluid
from line.
3. Raise vehicle.
4. Remove front splash shield
5. Disconnect the quick connect fittings (1) on the cooler hose going to the cooler using special tool 8875.
INSTALLATION
NOTE: Before installing power steering hose, replace used o-rings as necessary. Clean hose ends, fittings and open ports with a lint-free cloth.
Lubricate o-rings with clean power steering fluid.