RAM SRT-10 Pickup V10-505 8.3L (2004)
Tilt Wheel Handle: Service and Repair
TILT LEVER KNOB RELEASE
REMOVAL
1. Remove the tilt lever handle.
2. Remove the steering column opening cover.
3. Remove the lower shroud.
NOTE: Use special care not to pry on the clockspring electrical connector when removing or installing the mounting screw located next to the
clockspring.
4. Remove the two mounting screws (3) from the tilt lever knob release bracket (1).
5. Disconnect the electrical harness plastic mounting tab (2) from the the bracket (1).
6. Unsnap the cable (2) from the bracket (1).
7. Remove the end of the cable (2) from the tilt lever knob release bracket (1).
INSTALLATION
