RAM SRT-10 Pickup V10-505 8.3L (2004)
install the replacement liner.
6. If necessary, remove the old spring tip liner (1).
INSTALLATION
1. With the prybar still inserted between the leaves, install a new spring tip liner onto the leaf.
2. Firmly seat the spring tip liner onto the leaf. A C-Clamp (1) can be used to compress the adjacent leaves together which will seat the liner retaining
pin into the hole.
NOTE: THE SPRING TIP LINER IS PROPERLY INSTALLED WHEN THE RETAINING PIN IS POINTING TOWARD THE PAVEMENT
AND THE WEAR PAD IS CONTACTING THE LEAF SPRING.
3. Apply a small amount of lubricant oil onto the tip liner wear pad.
4. Install all the spring tip liners.
5. Place one spring clinch clip isolator (1) onto the outboard side of the spring clinch clip and one isolator on the inboard side of the spring clinch
clip.