RAM SRT-10 Pickup V10-505 8.3L (2004)
Drive/Propeller Shaft: Service and Repair
Shaft-Propeller Rear
SHAFT-PROPELLER REAR
REMOVAL
1. With vehicle in neutral, position vehicle on hoist.
2. Mark pinion flange (3) or yoke and propeller shaft (1) flange (4) or yoke for installation reference.
3. Mark the outline of the center bearing (1) on the crossmember for installation reference, if equipped.
4. Remove center bearing mounting nuts (3), if equipped.
5. Remove pinion flange or yoke clamp bolts.
6. Slide propeller shaft back on transmission then mark the shaft and transmission for installation reference.
7. Remove propeller shaft from transmission/transfer case.
INSTALLATION
1. Slide slip yoke onto the transmission/transfer case output shaft with reference marks aligned.
2. Align and install center bearing on crossmember, if equipped and tighten nuts to 54 Nm (40 ft. lbs.).
