Rampage L4-135 2.2L (1983)
Turn Signal Switch: Service and Repair
Fig. 4 Turn signal switch replacement
1. Disconnect battery ground cable.
2. Remove horn button, three screws and the horn switch.
3. Remove steering wheel nut, then the steering wheel using a suitable puller.
4. Remove lower steering column cover attaching screws, then the column cover.
5. Remove wipe/wash switch attaching screw and position switch aside.
6. Disconnect turn signal and hazard warning switch electrical connector, then disengage wiring harness from support bracket.
7. Remove three turn signal switch attaching screws.
8. Remove turn signal and hazard warning switch while guiding wire harness out from column.
9. Reverse procedure to install.
