Shadow L4-135 2.2L SOHC VIN D FI (1992)
Fuel Supply Line: Service and Repair
Fuel Fittings
1.
Disconnect the negative battery cable.
2.
Release fuel system pressure.
Warning: Wrap shop towels around hoses to catch any gasoline spillage.
3.
Remove the quick connect fitting from the fuel tube by pushing in on the plastic ring located on the end of the fitting. Gently pull the fitting from
the fuel tube.
4.
Cut off the crimped ferrules at each end of the hose, taking care not to damage the quick connect fitting or the fuel tube.
5.
Discard the ferrules, hose and damaged quick connect fitting.
6.
Replace the hose using hose marked EFM/EFI.
7.
Attach the replacement hose to the quick connect fitting and fuel tube using the hose clamps with "rolled edge construction" only, to prevent the
edge of the clamp from cutting the hose, and causing a high pressure fuel leak.
8.
Tighten hose clamps to 1 Nm (10 in-lbs) torque.
Caution: When using the ASD Fuel System Test, the ASD relay and fuel pump relay remain energized for 7 minutes or until the test is stopped, or until
the ignition switch is turned to the Off position.
9.
Using a scan tool, activate the ASD relay, and pressurize the fuel system. Check for leaks.
