Shadow L4-153 2.5L SOHC Turbo (1989)
Headlamp Dimmer Switch: Service and Repair
Dimmer Switch Replacement
Disable airbag, refer to Air Bags and Seat Belts/Air Bags (Supplemental Restraint Systems)/Service and Repair. After procedure has been
completed, rearm airbag system.
LESS TILT COLUMN
1. Disconnect battery ground cable, then disconnect electrical connector from switch.
2. Remove two screws attaching switch to column.
3. Reverse procedure to install. During installation, gently push up on switch to take up slack on rod.
Dimmer Switch Installation
WITH TILT COLUMN
1. Disconnect battery ground cable, then disconnect connector from switch.
2. Remove two switch mounting screws and disengage switch from pushrod.
3. To install switch, firmly seat pushrod into switch, then compress switch until two .093 inch drill shanks can be inserted into alignment holes.
Position upper end of pushrod in pocket of washer/wiper switch. This can be done by feel, or if necessary, by removing lower column cover.
4. Apply a light rearward pressure on switch, then install screws and remove drills. The switch should click when lever is lifted, and again as lever
returns, just before it reaches its stop in the down position.
5. Reconnect wiring connector to switch and connect battery ground cable.
