Shadow L4-153 2.5L SOHC Turbo (1989)
Heated Glass Element: Service and Repair
REPAIR PROCEDURES (GRID LINES TERMINALS AND PIGTAILS).
1. Mask repair area so conductive epoxy can be extended onto the line or the buss bar.
2. Follow instructions in repair kit for preparing damaged area.
3. Remove package separator clamp and mix plastic conductive epoxy thoroughly, fold in half and cut center corner to dispense epoxy.
4. For grid line, mark off area to be repaired with masking tape.
5. Apply conductive epoxy through slit in masking tape overlapping both ends of the break.
6. For a terminal or pigtail replacement, mask adjacent areas so epoxy can be extended onto line as well as buss bar. Apply a thin layer of epoxy to
area where terminal was fastened and to adjacent line.
7. Apply a thin layer of conductive epoxy on terminal and place terminal on desired location. To prevent terminal from moving while the epoxy is
curing, it must be wedged or clamped.
8. Carefully remove masking tape from grid line.
9. Allow epoxy to cure 24 hours at room temperature or use heat gun with a 260°-371°C (500°- 700°) range for 15 minutes. Hold gun approximately
254mm (10 inches) from repaired area.
WARNING: REPAIR KIT MAY CAUSE SKIN OR EYE IRRITATION.
CONTAINS EPOXY RESIN AND AMINE TYPE HARDENER, HARMFUL IF SWALLOWED. AVOID CONTACT WITH SKIN AND EYES. FOR
SKIN, WASH AFFECTED AREAS WITH SOAP AND WATER. DO NOT TAKE INTERNALLY. IF TAKEN INTERNALLY, INDUCE
VOMITING; CALL A PHYSICIAN IMMEDIATELY. IF IN CONTACT WITH EYES, FLUSH WITH PLENTY OF WATER. USE WITH
ADEQUATE VENTILATION. DO NOT USE NEAR FIRE OR FLAME. CONTENTS CONTAIN 3% FLAMMABLE SOLVENTS.
