Shadow V6-181 3.0L SOHC (1994)
Constant Velocity Joint: Service and Repair
Inner CV Joint Service
DISASSEMBLE
1. Remove clamp and boot from joint and discard.
Fig.6 Driveshaft Components
2. On GKN units, Clamp interconnecting bar in a vise and hold C/V joint housing on an angle. Gently pull on housing until one of the rollers is free.
Continue to hold housing on an angle and continue to pull on the housing until all roller are free.
3. On SSG units, use a flathead screwdriver to, pry wire ring out of groove and slide tripod from housing. When removing housing from tripod, hold
rollers in place on the trunnion studs to prevent rollers and needle bearings from falling out. After tripod is out of housing, secure rollers in place
with tape.
