Shadow V6-181 3.0L SOHC VIN 3 FI (1993)
Temperature Gauge: Testing and Inspection
Temperature Gauge Test
Coolant Temperature Gauge
Disconnect terminal from temperature sending unit on engine, then connect test lead of tester C-3826A to terminal and second test lead to ground. Place
pointer of gauge tester on E position and turn ignition switch to the On position. The temperature gauge should show C plus or minus 1/8 inch.
Place pointer of tester on the 1/2 position, the gauge should advance to the operating range left of 1/2 position of the dial. Place pointer of the tester in
the F position, gauge should advance to H position of the dial. If gauge responds to test correctly, but does not operate when terminal is attached to
sending unit, replace gauge.
Multiple Gauge Inoperative
1.
Run engine until normal operating temperature is reached. Record gauge position.
2.
Turn ignition Off and remove temperature gauge assembly from cluster.
Instrument Cluster With Tachometer
Instrument Cluster Without Tachometer