Shadow Convertible L4-135 2.2L SOHC (1991)
Convertible Top: All Technical Service Bulletins
Header Seal - Installation Recommendations
NO.: 23-03-92
GROUP:
BODY
DATE:
Feb. 10, 1992
SUBJECT:
Scuffing and Cleaning Header Seal Before Installation Supplement to TSB No. 23-08-91
MODELS:
1991 (AP) SHADOW CONVERTIBLE
DISCUSSION:
Ongoing development of the header seal installation procedures has determined that scuffing the body contact surface of the header seal and then
cleaning the seal will improve the adhesion between the seal and the two-way tape on the adjacent body surface as shown. This will aid in the prevention
of repeat water leaks through the header seal area.
Scuff the surface with a medium grit sandpaper. To clean the header seal, use a cleaning solution such as 3M General Purpose Adhesive Cleaner (08984)
or Kent Industries Acrysol (20005) and wipe any residue from the seal.
This procedure should be noted on page 7 of Technical Service Bulletin 23-08-91 and performed whenever header seals are being installed.
POLICY:
Information only.
