Shadow Convertible L4-135 2.2L SOHC (1991)
37.
Attach the header exterior molding isolator to the exterior molding by hooking the edge of the isolator under the forward edge of the exterior
molding. Center the clips within the notches on the isolator. Attach the isolator a foot at a time and tape the seal to temporarily hold it in place as it
is installed (Fig. 9).
NOTE:
TO INSTALL THE ISOLATOR, GRASP THE ISOLATOR WITH THE THUMB AND FOREFINGER. SQUEEZE THE OUTSIDE EDGES OF THE
ISOLATOR TOGETHER SPREADING THE TABS APART ON THE CHANNEL.
38.
Apply clear silicone to the base of each exterior molding stud.
39.
Carefully remove the tape and install the exterior molding to the header.
A.
Install the header corner seal using 3M Weatherstrip Adhesive (08011). It may require trimming as shown (Fig. 7).
B.
Install the header exterior molding aftaching nuts provided in the package.
CAUTION:
DO NOT OVER TIGHTEN THE ATTACHING NUTS, DIMPLING OF THE MOLDING MAY RESULT. TIGHTEN ATTACHING NUTS UNTIL
SNUG.
No. 1 Bow Garnish Removal
