Shadow Convertible L4-135 2.2L SOHC VIN D FI (1992)
Air Door Actuator / Motor: Service and Repair
Blend Door Actuator Replacement
CAUTION: Do not remove any of the motor actuators from the Heater/AC unit assembly with any electrical power applied. Removal should only be
done with the Ignition OFF and battery cable removed. The actuators have no mechanical stops to limit their travel. if the actuator rotates and is not
connected to the unit assembly, It will become uncalibrated.
REMOVAL AND INSTALLATION
Blend-Air Door Actuator
1. Remove under panel silencers.
2. Remove the carpeted cover over the air bag control module.
3. Remove floor air distribution duct.
4. Locate and remove three actuator attaching screws.
5. Lower the blend-air door actuator from A/C heater housing while removing actuator from blend-air door shaft.
6. Disengage wire connector lock and unplug connector.
To install, reverse the preceding operation.
Caution: Align the blend-air door shaft to the slot In the actuator. Be sure the shaft on blend-air door actuator Is properly engaged (when
installing) to prevent damage.
Perform system check.
