Shadow Convertible L4-153 2.5L SOHC (1994)
Convertible Top: Adjustments
Convertible Top Adjustments
When a convertible top component is aligned to proper fit and finish specifications, weatherstrips and seals will not always make proper contact. In these
cases, the use of shims, spacers, caulking putty and foam adhesive backed tape will be required to gain proper seal compression. Align weatherstrip and
seal channels or retainers so the contact surfaces are smooth and make full contact with mating surfaces. A paper strip, equal in size to a dollar bill,
should be able to be drawn through the contact surfaces without tearing the paper. A reasonable amount of effort should be required to pull the paper
through.
Bolt on body panels should be aligned to the weld on body components. The door should be aligned to the quarter panel, rocker panel and A-pillar. The
gaps between panels should be as equal as possible. When the door is fitted properly, the door glass can be aligned to roof rail and A-pillar weatherstrips.
After verifying the door and door glass alignment, the quarter glass can be aligned to the door glass and rear roof rail.
