Shadow Convertible L4-153 2.5L SOHC (1994)
Fig 47 Modulator Assembly Secondary Check Valve Circuit Bleed
a. Connect a clear bleed tube to check valve circuit bleeder screw, then submerge other end of tube in a clear container of clean brake fluid.
b. Have an assistant pump brake pedal several times, then maintain a constant, relatively heavy pressure on pedal.
c. Open check valve circuit bleeder screw at least one full turn; when brake pedal bottoms, tighten screw, then release pedal.
d. Repeat steps until fluid flowing through clear tube is free of air bubbles, then torque bleeder screw to 80 in. lbs.
9. Bleed modulator assembly primary sump circuit as follows:
Fig 48 Modulator Assembly Primary Sump Circuit Bleed
a. Connect clear bleed tube to primary sump bleeder screw, then submerge other end of tube in a clear container of clean brake fluid.
b. Have an assistant pump brake pedal several times, then maintain a constant, relatively heavy pressure on pedal.
c. Open modulator assembly primary sump circuit bleeder screw at least one full turn; then, using DRB scan tool, select "Bleed ABS Hydraulic
Unit" mode.
d. While in this mode, select "Primary Circuit" continuously until fluid flows freely through bleed tube without air bubbles.
e. If brake pedal bottoms out before an air free flow of fluid can be maintained, repeat sump circuit bleed procedure.
f.
When sump circuit has been fully bled, torque bleeder screw to 80 in. lbs.
10. Bleed modulator assembly primary accumulator circuit as follows:
