Shadow Convertible L4-153 2.5L SOHC (1994)
Brake Master Cylinder: Service and Repair
Master Cylinder Reservoir Replacement
Fig 21 Type 1 Master Cylinder Reservoir Replacement
REMOVAL
1. Remove master cylinder from vehicle as described previously.
2. Thoroughly clean reservoir and housing.
3. Remove reservoir caps, then drain the brake fluid.
4. Clamp housing in a vise.
5. Grasp reservoir by hand, then separate it from the housing by rocking it from side to side. Do not pry reservoir from the housing.
6. Remove grommets from housing.
INSTALLATION
1. Install grommets in housing.
2. Apply clean brake fluid to reservoir mounting surface.
3. Position reservoir to housing so wording on reservoir reads from left to right from the front of the housing.
4. Press reservoir into housing while rocking it from side to side. Reservoir is properly seated when bottom of reservoir touches the grommet.
5. Refer to Hydraulic System/Service and Repair/Brake System Bleed to bleed the hydraulic system.
