Shadow Convertible L4-153 2.5L SOHC (1994)
4.
Secure the steering wheel in a suitable fixture. Drill out both speed control mounting holes using a 1/4" (6 mm) drill (See Illustration).
5.
Using 80 to 180 grit sandpaper, clean the paint off both the top and bottom sides of metal mounting surface. Using a round file or knife, clean out
both guide pin holes where the speed control switch mounts (See Illustration).
6.
Clean loose debris from the sanded area. Using Naphtha cleaning solvent on a clean rag, thoroughly wipe the sanded area on both sides of the
steering wheel. Make sure screw and guide pin holes are also cleaned out with solvent. Allow 2-3 minutes for cleaner to evaporate.
NOTE:
USE ONLY NAPHTHA CLEANING SOLVENT. ANY OTHER SOLVENT WILL NOT BE EFFECTIVE FOR THIS PROCEDURE. WHEN
USING NAPHTHA, FOLLOW ALL MANUFACTURERS WARNINGS AND RECOMMENDATIONS AND AVOID CONTACT WITH
PLASTIC SURFACES.
7.
Reinstall the steering wheel back cover, steering wheel and all other parts removed in Step 2.
8.
Install new speed control switch, P/N 4565265, using two new screws, P/N 6032986.
NOTE:
THE OLD SPEED CONTROL SWITCH MOUNTING SCREWS MUST NOT BE REUSED, AS THEY MAY BE CONTAMINATED WITH
LUBRICANT.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No: 08-85-30-93 0.5 Hrs.
FAILURE CODE: BF - Broken
