Shadow Convertible L4-153 2.5L SOHC Turbo (1991)
68.
Loosen the door glass upstop and raise the glass to the upper limit to allow the glass to achieve better contact with the side rail weatherstrip (Fig.
15). Tighten the upstop bolt and check the glass-to-seal fit. Install the door trim panel.
69.
Latch the top to the header.
70.
Secure the tab on the header seal and gutter seal to the header reinforcement with two screws provided (Fig. 16).
NOTE:
POSITION THE HEADER SEAL TAB AND INSPECT IT FOR EXACT ALIGNMENT. IF THE TAB HOLES DO NOT LINE UP WITH THE
A-PILLAR HOLES, DRILL NEW HOLES AS NECESSARY IN THE A-PILLAR AND THEN ATTACH THE HEADER SEAL AND GUTTER
SEAL TAB. THE GUTTER SEAL WILL HANG LOOSE INSIDE THE VEHICLE UNTIL THE A-PILLAR MOLDING IS INSTALLED.
Door End Cap Installation
71.
Lower the windows. While holding the door end cap in place, open and close the door to verify the correct contact to the header seal (Fig. 17).
Mark the location of the end cap on the door A-pillar.
72.
While maintaining the position of the door end cap, drill two 1/8 in. (3.17 mm) holes into the door A-pillar using the holes in the end caps as a
locator. Use a 1/2 in. drill stop on the drill bit to limit the drill bit travel.
