Shadow Convertible L4-153 2.5L SOHC Turbo (1991)
73.
Fold the foam seal provided in half, by sticking it together. Apply a small dab of petroleum jelly on the edge of the foam seal to aid in installation.
Then install the foam seal using 3M Weatherstrip Adhesive (08011), between the end cap and door in the notched area (Fig. 18).
74.
Attach the door end cap with the two black rivets provided. File the pop rivet mandrels flush if they are protruding. Inspect the door end cap by
opening and closing the door again and verify proper function and alignment.
75.
Attach the extender to the door surface using 3M Weatherstrip Adhesive (08011). Apply the adhesive on the underside of the extender. Apply
clear silicone sealer along the bottom edge of the end cap to prevent water entry.
Windshield Header Garnish Molding Installation
76.
Drill a 9/64 in. (3.5 mm) diameter hole in the header seal corner flap and A-pillar (apply rust prohibitive paint to hole) (Fig. 19).
77.
Apply 3M Weatherstrip Adhesive (08011) to the header seal corner flap as indicated. Install the push pins provided to secure each header seal
corner flap to the A-pillar.
78.
Inspect the area around the A-pillar and header for any holes or gaps where water might enter. If holes or gaps are present, seal with Mopar
Silicone Rubber Adhesive Sealant (4318025).
79.
Install the header garnish.
